24 14 004 Replacing shaft seal for selector shaft (GA8HP45Z)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

IMPORTANT:

Do not let skin come in contact with transmission oil and do not inhale fuel vapours.
Wear protective gloves.
Ensure adequate ventilation.

IMPORTANT: After completion of repair work, check TRANSMISSION OIL LEVEL .
Use only approved gearbox oil .
Failure to comply with this requirement will result in serious damage to the automatic transmission!

Necessary preliminary tasks:

Remove TRANSMISSION .
Remove MECHATRONICS .

Using a suitable tool, drive clamping sleeve (1) out of selector shaft.

Withdraw selector shaft (2) outwards.

NOTE: Return spring is under tension.

Installation note:

Replace selector shaft (2).

Replace clamping sleeve (1).

Insert narrower end of clamping sleeve (1) into hole first. Using a suitable tool, drive in clamping sleeve until it is flush with the hole.

Fig 1: Driving Clamping Sleeve Out Of Selector Shaft

Screw in special tool 24 5 367 until it is firmly connected with radial shaft seal.

Fig 2: Identifying Special Tool (24 5 367)

Screw special tool 24 5 362 onto special tool 24 5 367 and tighten down.

This pulls the shaft seal out of the transmission housing.

Fig 3: Identifying Special Tools (24 5 362) And (24 5 367)

Oil sealing lip on shaft seal (1).

Drive radial shaft seal (1) fully home using special tool 24 5 366 and plastic hammer.

Fig 4: Identifying Shaft Seal And Special Tool (24 5 366)