24 00 018 Adjusting the gearshift lever\PREMIUM
WARNING: This page is about a different variant/trim than selected.
Overview of Activities
Additional Information
Main Work
- Adjust selector lever
General information
MAIN WORK
- Adjust selector lever
Prerequisite
Cable is freely accessible. Selector lever in selector lever position P (Park).
- Make sure the gear selector cable head (2) is correctly clipped on.
- Loosen screw (3).
- Press and hold the lever (1) towards the front into position P (Park).
- Crank the propeller shaft to make sure that the transmission is in position P (Park).
- Pull the cable (4) towards the rear and release it.
- Tighten down screws (3).
CLAMPING BOLT TO LEVER TORQUE SPECIFICATION
| 10 Nm |