23 00 038 Installing exchange gearbox (GS6-17BG)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
After completion of repair work, check TRANSMISSION OIL LEVEL .
Use only approved GEARBOX OIL .
Use only approved GEARBOX OIL .
Failure to comply with this instruction will result in serious damage to the transmission.
Recycling:
Catch and dispose of escaping transmission oil.
Observe country-specific waste disposal regulations
Necessary preliminary tasks:
- Drain transmission oil at oil drain plug.
Tightening torque 23 00 4AZ .
- Remove TRANSMISSION .
Transfer gearshift rod joint.
Slide back retaining ring (1) and drive out cylinder pin (2).
NOTE:
Check damping disc (6) for damage and replace if necessary.
Convert following components from previous transmission to new transmission.
- RELEASE BEARING AND RELEASE LEVER
- Ball pin and wire spring clip
- If applicable, stud bolts for clutch slave cylinder.
- Reversing light switch
- Tightening torque 23 11 1AZ .
- If necessary zero-gear sensor
- Replace screws
- Tightening torque 23 14 2AZ .
Reassemble the vehicle.
Check oil level.
Installation note:
Observe GREASING SPECIFICATION .