12 14 523 Replacing pulse sensor on intake camshaft (N20)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Unlock connector (1) and remove.

Release screw.

Tightening torque 13 62 1AZ .

Remove pulse sensor (2).

Check gasket, replace damaged gasket.

Fig 1: Identifying Pulse Sensor Connector And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault message.
Delete fault memory.