17 11 052 Removing and installing left module carrier

WARNING: This page is about a different variant/trim than selected.

WARNING: Risk of scalding!
Only perform this repair work after engine has cooled down.

Necessary preliminary tasks:

Loosen bolts (1) on radiator on left and right.

Tightening torque 17 10 2AZ .

Do not unlock or detach the coolant hose (2).

Do not drain coolant.

Fig 1: Identifying Radiator Bolts And Coolant Hose

Courtesy of BMW OF NORTH AMERICA, INC.

Slide the cooler and capacitor slightly to the rear.

Lift out module carrier (1) left to the top and remove.

Fig 2: Removing Left Module Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

When reinstalling the module carrier (1) the correct fit of the cooler in the bracket (2) must be ensured!

Fig 3: Identifying Module Carrier And Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Reassemble the vehicle.