62 30 010 Removing and installing/renewing head-up display
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on protection against electrostatic discharge (ESD PROTECTION)
.
IMPORTANT:
Comply with notes and notes on HANDLING OPTICAL FIBRES
.
Risk of damage!
Do not scratch lens of head-up display.
Risk of damage!
Do not scratch lens of head-up display.
Necessary preliminary tasks:
- Remove INSTRUMENT PANEL TRIM
Release screw (1) on carrier housing (2) at bottom.
Tightening torque: see 1AZ in 62 30 HEAD-UP DISPLAY .
Remove sound insulation (1) from head-up display (4).
Disconnect plug connections (2).
Release screws (3).
Tightening torque: see 1AZ in 62 30 HEAD-UP DISPLAY .
Carefully feed out head-up display (4) in upward direction.
Installation note:
Clean lens of head-up display.
Adjust HEAD-UP DISPLAY .
Replacement:
Carry out VEHICLE PROGRAMMING/ENCODING .