63 10... Adjust the high-beam headlight (with electronic headlight adjustment device MAHA Lite 3)
- The low-beam headlight and high-beam headlight are located in separate housings and each has a separate range of adjustment (e.g. E52).
- Low-beam headlight and high-beam headlight are located in one housing with one separate range of adjustment each.
- With separately mounted additional headlight (e.g. MINI).
For vehicles from 1995, a separate adjustment of the high-beam headlight is not possible (except E52, accessory headlight MINI) .
COMPLY with test prerequisites for headlight adjustment.
Refer to the manufacturer's operating instructions for the headlight adjustment device!
Necessary preliminary tasks:
Switch on the headlight adjustment device by pressing any button.
Press F1 button. The shown display screen appears.
Perform the following settings:
- The passenger car must be selected.
- Enter the setting dimension of the headlight via the buttons F1/F2: - 1.0 % to - 1.1 %
- The right / left-hand traffic must be selected according to the country.
- Select the headlight type via the button F3:
- EC: for halogen and xenon headlights
- EC LED: for LED headlight
The adjusted values are adopted for future measurements.
Press the button for the applicable side of the vehicle (1) briefly . The measured values are shown in the display. Symbol (2) will be displayed.
When the high-beam headlight has been adjusted correctly, "OK" will be displayed:
- O. K. (4): Setting is correct. However, a more accurate setting is possible.
- OK (5): The setting is absolutely correct. A more accurate adjustment is no longer possible.
When a high-beam headlight adjustment is incorrect, arrows (3) will be displayed. Use the arrows (3) to adjust the high-beam headlight.