65 77 534 Removing and installing/replacing front right sensor (US version only)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT RIGHT WHEEL ARCH TRIM

NOTE: This operation depends on the engine version.

Release screw (1) on auxiliary radiator bracket (2).

Remove auxiliary radiator bracket (2) and carefully place to one side.

Installation:

Fig 1: Identifying Auxiliary Radiator Bracket And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Auxiliary radiator bracket (2) must be correctly seated in the designated guides.

Release screws (1).

Tightening torque: see 2AZ in 65 77 AIRBAG TRIGGERING CONTROL .

Feed out acceleration sensor (2).

Unlock plug connection (3) and disconnect.

Installation:

Make sure acceleration sensor (2) is in correct installation position.

Sensor surface of acceleration sensor (2) must point upwards!

Plug connection (3) must point in opposite direction to direction of travel.

Fig 2: Identifying Acceleration Sensor, Screws And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.