37 12... Replacing pipes for air springs: Notes
Drain the air spring system before carrying out any work on the air supply unit, air pipes and air springs! Danger of injury if this instruction is not complied with!
Risk of damage!
Extreme cleanliness must be ensured in the connection area of the pipes during removal and installation. Even the smallest of dirt particles can cause leakage in the air spring system.
Necessary preliminary tasks:
- Pull out fuse for air supply unit in luggage compartment at rear right
- Remove rear left and right WHEEL ARCH COVERS
- Remove rear BUMPER TRIM
Draining air spring system:
Carefully slacken screw connection of pipe (1) until the sound of escaping air can be heard.
Tightening torque 37 12 1AZ .
Installation:
Install new SCREWED CONNECTION .
Removing panel from air supply unit on underbody at rear:
Unscrew nuts (1).
Release screws (2).
Lever out expander rivets (3) and remove panel (4) from air supply unit.
To avoid leaks in the air spring system, it is essential to avoid scratches on pipes in particular in the connection area!
Line, air spring, left: "Red"
Line, air spring, right: "Blue"
Pipes must have sufficient clearance to adjoining components!
Pipe routing, left (red pipe)
Detach pipe from air supply unit (1) and air spring strut (2).
Then seal air supply unit and air spring strut with adhesive tape.
Unclip pipe from holder (see arrows in illustration).
Installation:
Install new SCREWED CONNECTIONS .
Carefully screw in banjo bolts by hand to avoid damaging the plastic threads and with it the air supply unit.
Tightening torque 37 12 1AZ .
Pipe routing, right (blue pipe).
Detach pipe from air supply unit (1) and air spring strut (2).
Then seal air supply unit and air spring strut with adhesive tape.
Unclip pipe from holder (see arrows in illustration).
Installation:
Install new SCREWED CONNECTIONS .
Carefully screw in banjo bolts by hand to avoid damaging the plastic threads and with it the air supply unit.
Tightening torque 37 12 1AZ .