16 13 521 Removing and installing/replacing pressure switch for Natural Vacuum Leak Detection (NVLD)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove CARBON CANISTER .
- Remove DUST FILTER .
Unlock and disconnect snap fastener (1).
Unfasten screws (2).
Pull off pressure switch (3) in direction of arrow.
Installation note:
Check gaskets and replace if necessary.