65 77 534 Removing and installing/replacing front right sensor (US version only)

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT RIGHT WHEEL ARCH TRIM .

NOTE: This operation depends on the engine version.

Release screw (1) on auxiliary radiator bracket (2).

Remove auxiliary radiator bracket (2) and carefully place to one side.

Installation:

Fig 1: Identifying Auxiliary Radiator Bracket And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Auxiliary radiator bracket (2) must be correctly seated in the designated guides.

Release screws (1).

Tightening torque 65 77 2AZ .

Feed out acceleration sensor (2).

Unlock plug connection (3) and disconnect.

Installation:

Make sure acceleration sensor (2) is in correct installation position.

Sensor surface of acceleration sensor (2) must point upwards!

Fig 2: Identifying Acceleration Sensor, Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Plug connection (3) must point in opposite direction to direction of travel.