65 77 532 Removing and installing/replacing front left sensor (US version only)

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT LEFT WHEEL ARCH COVER .

NOTE: This work step varies according to engine type.

Fig 1: Identifying Auxiliary Radiator Bracket And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) on auxiliary radiator bracket (2).

Remove holder (2) and carefully place to one side.

Installation:

Holder (2) must be correctly seated in the designated guides.

Release screws (1) on lock carrier (2).

Tightening torque 65 77 2AZ .

Feed out sensor (3).

Unfasten plug connection (2) and disconnect.

Installation:

Make sure sensor (3) is in correct installation position.

Sensor surface must point upwards.

Fig 2: Identifying Lock Carrier, Plug Connection, Sensor And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Plug connection (2) must point in opposite direction to direction of travel.