35 11 000 Removing and installing (replacing) complete bearing support for foot pedal
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
After completion of work, carry out function check.
Necessary preliminary work:
- Remove BRAKE SERVO .
Release screws (1).
Remove control units from holder (2). Plugs remain connected.
Slacken nut (1).
Installation note:
Replace self-locking nut.
Tightening torque 35 11 2AZ.
Remove bearing support (2).
Unclip line (1).
Disconnect plug connection (2).
Replacement:
- Modify brake light switch.
- Modify holder for control units.