52 14 209 Removing and installing carrier plate for rear monitor

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

52 0 050

Necessary preliminary work:

Remove REAR MONITOR .

Release tacker in marked area from carrier plate (1).

Remove clamps (2) at top left and right.

Fig 1: Identifying Carrier Plate And Clamps

G06895177

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Remove carrier plate (2).

Fig 2: Identifying Carrier Plate And Nuts

G06895178

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Mount head restraint to pretension backrest cover.

The seam of the backrest cover must not be wavy and must be flush with the backrest frame top edge.

Align backrest cover centrally.

Tack backrest cover with pneumatic tacker front inside outwards to carrier plate (1).

Tack on carrier plate at top.

Tack on left and right in side area.

Bend new clamps closed with pliers 52 0 050 .

Backrest cover must not show any folds.