51 23 211 Removing and installing/replacing pull cable for hood/bonnet locks at front

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove TOP REAR CONNECTION

Unclip clutch housing Bowden cable (1) at marked points.

Installation note:

Clips must not be damaged.

To open up clutch housing cover, lever up cover (2) in direction of arrow.

Fig 1: Identifying Clutch Housing Bowden Cable And Clutch Housing Cover Opening Direction

G06885616

Courtesy of BMW OF NORTH AMERICA, INC.

Feed rear Bowden cable (2) out of sliding carriage (1) and clutch housing (3).

Fig 2: Identifying Rear Bowden Cable, Sliding Carriage And Clutch Housing

G06885617

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Shown removed here for purposes of clarity.

Pull back retaining spring from release lever (1).

Feed Bowden cable (2) out of release lever (1) and catch carrier (3).

Repeat procedure on second bonnet lock.

Unthread cable for bonnet locks and remove.

Fig 3: Identifying Bowden Cable, Release Lever And Catch Carrier

G06885621

Courtesy of BMW OF NORTH AMERICA, INC.