Attach front spoiler

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The operation is shown on the left side; proceed in the same way for the right side.

Pull off liner (1) only partly and secure with adhesive tape (2) to outside of front spoiler.

Pull off complete liner (3).

Place front spoiler (4) on bumper and align.

Pull off the liner (1) gradually and simultaneously press against the bumper panel. Make sure the front spoiler (4) is correct fitted.

Fig 1: Identifying Front Spoiler, Liner And Adhesive Tape

Courtesy of BMW OF NORTH AMERICA, INC.

Secure the front spoiler (1) in the area of the wheel arch with clamp (3) and paint protection (2) on left and right.

Fix front spoiler (1) in place in the intake area using suitable rigid foam blocks (4) approx. 105 mm high and adhesive tape (5).

NOTE: Always work with suitable paint protection.

Fig 2: Identifying Spoiler, Hard Foam Blocks, Adhesive Tape, Wheel Arch And Clamp

Courtesy of BMW OF NORTH AMERICA, INC.

Remove emerging adhesive immediately.

Secure bumper panel using plastic rivets (1) and screws (2).

Fig 3: Identifying Bumper Panel Plastic Rivets And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Allow adhesive to set for 24 hours at a temperature of min. 15 °C.
24 hours, 100 km/h maximum speed.
Mechanical strain permitted after 2 days at the earliest (e.g. car wash).