31 35 000 Removing and installing/replacing front anti-roll bar

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT UNDERBODY PROTECTION .
Remove BOTH ANTI-ROLL BAR LINKS FROM ANTI-ROLL BAR .

Release screws (1).

Tightening torque 31 35 1AZ .

Remove anti-roll bar (2) downwards.

Fig 1: Identifying Anti-Roll Bar And Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 2: Identifying Anti-Roll Bar Retaining Bracket Nose And Lower Mounting Plate Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace screws.

Pay attention to installation location of retaining bracket and mounting plate!

Nose (1) on retaining bracket must point left in direction of travel.
Curve (2) on lower mounting plate points to rubber bearing.