32 41 331 Replacing pressure line for power steering (from steering gear to junction)

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

DANGER OF POISONING if oil is ingested/absorbed through the skin!

RISK OF INJURY if oil comes into contact with eyes and skin!

IMPORTANT:

Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.

Close off line connections with seal plugs.

Recycling:

Catch and dispose of hydraulic fluid in a suitable collecting vessel.

Necessary preliminary work:

Draw off and dispose of hydraulic fluid from oil reservoir.
Release hydraulic steering gear.
Lower FRONT AXLE SUPPORT .

Release screw (1) and remove pressure line (2) from steering gear.

Tightening torque 32 41 5AZ

Fig 1: Identifying Pressure Line And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Remove return hose (1) from holder (2).

Fig 2: Identifying Return Hose And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque 32 41 15AZ

Release nut (2) on holder.

Tightening torque 32 41 7AZ

Disconnect pressure line (3).

Installation note:

Replace all sealing rings.

Make sure hydraulic line is laid without tension and with sufficient distance to adjoining components.

Fig 3: Identifying Pressure Line, Nut And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Fill and bleed HYDRAULIC SYSTEM .
Check line connections for leaks.