84 11 519 Removing and installing/replacing eject box

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove complete CENTRE CONSOLE

Release cable tie (1).

Unlock retaining lugs (2).

Press eject box (3) upwards.

Installation:

Replace cable tie (1).

Retaining lugs must not be damaged.

Fig 1: Identifying Eject Box With Cable Tie And Retaining Lugs

Courtesy of BMW OF NORTH AMERICA, INC.

Remove eject box (1) upwards from centre console (2).

Installation:

Ensure correct cable routing.

Fig 2: Identifying Eject Box And Centre Console

Courtesy of BMW OF NORTH AMERICA, INC.