1. Definitions of terms

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

REPAIR INSTRUCTIONS FOR HYDRAULIC SYSTEM OF SOFT TOP AND SOFT TOP COMPARTMENT LID

Hydraulic system at zero pressure or Untensioned state:	Turn ignition lock to "0" position. E46c: Wait 15 secondsE52: Wait 2 minutesE85: Emergency operation or wait 2 minutesE64: Wait 5 seconds.	Hydraulic system has no or only very low pressure
Mechanical operation: Emergency operation:	Soft top is opened or closed by hand Always move soft top with aid of a second person	Observe Point 3
Closed system:	All lines are connected	Even "short circuiting" of lines is possible
Function check:	Open and close soft top several times (min. 3 times) Check fluid level in hydraulic unit; if necessary, top up fluid	Refer to Operating Instructions
Short circuit (E46c only):	Unfastening of quick-release couplings Connection of supply and return lines	Hydraulic system cannot build up pressure Soft top can be moved
Function check:	Checking of soft top function if possible on removed soft top	Soft top must be secured! Move 2-3 times
Soft top stowed:	Soft top fully open (folded together)	When the soft top is installed, it is in the closed soft top compartment