1. General information on handling rubber seal profiles

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

If seals reveal partly detached protective film on delivery, they must not be bonded.
Store seals at 15 °C to 25 °C.
If, during the handling, the protective film has come off before bonding, it can still be bonded.
Bonding at room and object temperature >20 °C. Temperatures between 40 and 50 °C significantly increase initial adhesion.
Seals, which are subjected to temperatures above 80 °C after gluing, will be very difficult to remove.