51 45 184 Removing and installing/replacing panel for pedals

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Move driver's seat completely towards rear

ECE only:

Release screws (1).

Pull back trim for pedal assembly (2).

Disconnect and unlock all plug connections.

Remove trim for pedal assembly (2).

Installation:

Make sure trim for pedal assembly (2) is correctly seated on footwell air outlet above.

Fig 1: Pulling Back Trim For Pedal Assembly (ECE)

Courtesy of BMW OF NORTH AMERICA, INC.

US only:

Release screws (1).

Pull back trim for pedal assembly (2).

Disconnect and unlock all plug connections.

Remove trim for pedal assembly (2).

Installation:

Make sure trim for pedal assembly (2) is correctly seated on footwell air outlet above.

Fig 2: Pulling Back Trim For Pedal Assembly (US)

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement

Remove FOOTWELL LIGHT (1).

Remove SPEAKER (2).

Remove AERIAL (3).

Fig 3: Identifying Footwell Light, Speaker And Aerial

Courtesy of BMW OF NORTH AMERICA, INC.