72 12 000 Removing and installing or replacing airbag module on passenger side
WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Read and comply with SAFETY REGULATIONS
for handling airbag modules and pyrotechnical belt pretensioners.
Incorrect handling can activate airbag and cause injury.
Incorrect handling can activate airbag and cause injury.
IMPORTANT:
Operations on pyrotechnical devices may only be carried out by authorized experts.
Improper, unauthorized operations may result in serious dangers.
Unauthorized persons are strictly prohibited from performing any operations on this system.
Improper, unauthorized operations may result in serious dangers.
Unauthorized persons are strictly prohibited from performing any operations on this system.
Necessary preliminary tasks
- Clamp off BATTERY NEGATIVE LEAD
- Remove RIGHT GLOVEBOX WITH HOUSING
Disconnect plug connection (1).
NOTE:
Secure airbag module (1) on passenger side against falling out.
Release nuts in marked area.
Installation:
Replace self-locking nuts.
Tightening torque 72 12 01AZ .
Remove airbag module (1) on passenger side towards bottom.