00 00... Tyres: checking inflation pressure, correcting if necessary (incl. spare wheel), checking external condition, tread depth, pattern

WARNING: This page is about a different car, the 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Checking tire inflation pressure

Check tire inflation pressure in accordance with information plate on B-pillar
The inflation pressure in the spare wheel must be 0.5 bar higher than the maximum specified value on the information plate
Initialize RUN FLAT INDICATOR

Check tire condition

Check tread depth of all tires with tire tread gauge
Check tire tread surfaces and side walls for incisions and foreign particles such as nails or screws
Check tire tread pattern for localized flattening and wear on one side; if necessary, carry out wheel/chassis alignment after consulting with customer and issue a separate invoice for this work

NOTE:

For details of approved wheel-tyre combinations, refer to KSD CD
For reasons of driving safety, only use tires of the same type and tread pattern on a single vehicle
Inform customer of any incorrect or worn tires