33 55 021 Replacing both rubber mounts for stabilizer mounting
WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
Release nuts and remove screws towards rear.
Tightening torque 33 55 1AZ .
Remove stabilizer from rear axle carrier.
Remove retaining bracket and rubber mount on both sides.
Installation:
Keep retaining bracket, rubber mount and stabilizer clean and free from oil and grease.
Replace self-locking nuts.