33 32 160 Removing and installing/replacing compression strut for rear axle carrier
WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe SAFETY INSTRUCTIONS
for raising the vehicle
Driving without the compression strut is not permitted!
Driving without the compression strut is not permitted!
Necessary preliminary tasks
- Remove EXHAUST SYSTEM .
- Remove tunnel thermal insulation
IMPORTANT:
Risk of damage!
Support rear axle carrier at front middle with workshop jack.
Support rear axle carrier at front middle with workshop jack.
Release nuts and remove compression strut.
Secure rear axle carrier by screwing on nuts.
Installation:
Replace self-locking nuts.
Tightening torque 33 32 7AZ .