33 32 044 Replacing one rubber mount in trailing arm for lower control arm

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove lower control arm from trailing arm . See 3332086 REMOVING AND INSTALLING/REPLACING BOTTOM LEFT CONTROL ARM or 3332087 REMOVING AND INSTALLING/REPLACING BOTTOM RIGHT CONTROL ARM

Measure and note protrusion (A) of old rubber mount.

Fig 1: Identifying Protrusion Of Old Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out rubber mount with special tools 33 3 331, 33 3 332, 33 3 333 and nut (1).

Fig 2: Pulling Out Rubber Mount Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

Draw in new rubber mount (1) with special tools 33 3 332, 33 3 333 and 33 3 334 to previously determined protrusion (A).

Fig 3: Installing Rubber Mount Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

After installation

Check that output shaft is correctly seated in rear differential.
Perform CHASSIS ALIGNMENT CHECK