33 17 004 Replacing all rubber mounts for rear axle differential mounting at front

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove REAR DIFFERENTIAL

Pull out rubber mount with special tools 33 3 314, 33 3 315, 33 3 361, 33 3 362 and an M12 nut (1).

Fig 1: Pulling Out Rubber Mount Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Observe installation position of rubber mount.
Fig 2: Protrusion (A) in rear direction of travel
Fig 2: Openings (1) in transverse vehicle direction

Coat new rubber mount and bearing bushing in rear axle carrier with Circo Light.

Fig 2: Identifying Rear Direction Of Travel Protrusion And Transverse Vehicle Direction Openings

Courtesy of BMW OF NORTH AMERICA, INC.

Draw in rubber mount (1) with special tools 33 3 314, 33 3 315, 33 3 362 and 33 4 173 as far as it will go.

Fig 3: Installing Rubber Mount Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.