Procedure For Additional Vehicle Identification Number

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Cross through original vehicle identification number.

Fig 1: Identifying Vehicle Identification Number Position

G06890522

Courtesy of BMW OF NORTH AMERICA, INC.

Remove ENGINE COMPARTMENT LID SEAL LOCATOR

= Original vehicle identification number (line 1).

Mark position lines (2) in accordance with specified dimensions/measurements.

Measurement a = 12 mm

Measurement b = 10 mm

Display input:

Select Layout 5 with arrow button.
Enter vehicle identification number with F10.
Press "ENTER" button.

NOTE: With Layout 5 the vehicle identification number (line 1) is crossed through.

Fig 2: Identifying Display

G06890523

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Perform stamping operation with position lines in advance on a test sheet.

Fig 3: Identifying Suction Feet Of Needle Stamping Unit Moving Position

G06890524

Courtesy of BMW OF NORTH AMERICA, INC.

Move suction feet of needle stamping unit to positions (1) and (2) shown.

First adjust position (1)
Then adjust position (2)

NOTE: Make sure the unit is resting securely in position. If necessary, adjust the height and position of the suction feet.

Press pushbutton (1) for vacuum pressure.

Then start stamping operation with pushbutton (2).

IMPORTANT: After completing the stamping operation, do not alter the position of the unit.
Do not switch off vacuum pressure.

Fig 4: Stamping Vehicle Identification Number

G06890525

Courtesy of BMW OF NORTH AMERICA, INC.