Removing Rear Trim Panel

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Release screws (1) and remove support (2).

Tightening torque 41 34 1AZ .

Version with automatic tailgate actuation:

Shut down AUTOMATIC READ LID ACTUATION .

IMPORTANT: Risk of damage to spindle drive: only move tailgate slowly by hand.
If necessary, remove spindle drive. See REMOVING LEFT SPINDLE DRIVE or REMOVING RIGHT SPINDLE DRIVE .

Fig 1: Identifying Screws And Support

Courtesy of BMW OF NORTH AMERICA, INC.

Open welded connections in areas (1).

Open welded connections in areas (2) from inside.

Remove rear trim.

Fig 2: Identifying Welded Connections Areas

Courtesy of BMW OF NORTH AMERICA, INC.