41 61 014 Adjusting Engine Compartment Lid: Notes

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The BATTERY NEGATIVE LEAD must be clamped off on vehicles with AFGS active pedestrian protection.
Do not damage adjoining body components.
Minor corrections (realignment work) are permitted if the existing adjustment options are not sufficient.

Carry over schematic representation to the relevant vehicle type.

NOTE: Observe 41 00... BODY GAP DIMENSIONS .

NOTE: Stop screw must not be damaged or missing. If necessary, replace hood/boot hinge.
The stop screw is preset and must not be used to adjust the hood/bonnet.

Fig 1: Locating Stop Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nuts (1) of hinges on left and right.

Hood lid must be able to be moved.

Tightening torque 41 61 1AZ .

NOTE: If adjustment range is not sufficient, slacken screws on body and slide hinge. (Refer to HEIGHT ADJUSTMENT AT HINGE )

Tightening torque 41 61 3AZ .

Fig 2: Identifying Hinges Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust engine hood/bonnet sideways and lengthways.

Retaining hooks must snap into place in locks.

Fig 3: Locating Engine Hood/Bonnet Adjustment Area

Courtesy of BMW OF NORTH AMERICA, INC.