LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2015 >> Z4 sDrive35is >> Repair and Diagnosis >> External Pages >> Different car >> Section 282 (Collision - Body Panel Repair (F01, F02)) >> Front Lid >> 41 61 010 Removing And Installing Engine Compartment Lid (Active Pedestrian Protection AFGS)

41 61 010 Removing And Installing Engine Compartment Lid (Active Pedestrian Protection AFGS)

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Danger of injury.
The BATTERY NEGATIVE LEAD must be clamped off on vehicles with AFGS active pedestrian protection.
Adhere to SAFETY INFORMATION so as to avoid a danger of injury by the actuator.
IMPORTANT: Support engine compartment lid in fully opened position with suitable apparatus.
Removal of the engine compartment lid must be carried out with the assistance of a second person.

Follow instructions on ACTIVE PEDESTRIAN PROTECTION  system.

Necessary preliminary work: 

Vehicles with  active pedestrian protection only:

Unscrew nuts (1).

Remove engine compartment lid.

Installation note: 

Install engine compartment lid at screw locations to on hinge.

Tightening torque 41 61 1AZ .

If necessary, adjust ENGINE COMPARTMENT LID  .

Fig 1: Identifying Engine Compartment Lid Nuts
G06890688Courtesy of BMW OF NORTH AMERICA, INC.