86 10... Removing rear supports and bracket: Installation

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Tightening Torque, 86 10 26AZ

Fig 1: Identifying Rear Support Of Bracket With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cable holders (1) from bracket (2).

Release screws (3) on left and right sides of bracket (2). Drill out rivets (4) from underside of platform. Drill out rivets (5) from upper side of platform.

Tightening Torque, 86 10 27AZ

Fig 1: Identifying Bracket With Cable Holder, Screws And Rivets

Courtesy of BMW OF NORTH AMERICA, INC.

Feed cable for rear light (1) through opening (2). Fit cable holders (4) in holes (3).

Fig 1: Identifying Rear Light And Cable Holder

Courtesy of BMW OF NORTH AMERICA, INC.