24 34... Manually releasing parking lock (from vehicle underbody) - GA6HP transmission

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2014 BMW Alpina B7L, 2014 BMW Alpina B7, and 2013 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

For various tasks, it is necessary to unlock and lock the parking lock.

This can be done from inside the passenger compartment or underneath the vehicle.

Before unlocking the parking lock, secure the vehicle against rolling away.

In the event of a power supply interruption, e.g. flat battery or electrical fault, the parking lock must be manually released, otherwise the wheels will be locked and the vehicle cannot be moved.

Manual emergency release of parking lock from passenger compartment is not possible with GA6HP/GA8HP gearboxes from 03/2010:

From production date 03/2010, the Bowden cable is no longer required for transmission unlocking for:
- F01/F02/F03 GA6HP

Before removing the underbody panel, always check inside the vehicle to be certain the parking lock emergency release is not fitted.

From the vehicle underbody:

Raise vehicle.

Manual emergency release of parking lock

Remove UNDERBODY PROTECTION
Screw in bolt (1) with hexagon socket (SW5) until parking lock is released by lever (2).

Fig 1: Tightening Bolt With Hexagon Socket (Sw5)
Courtesy of BMW OF NORTH AMERICA, INC.

Then unscrew and remove screw (1).

Screw (1) should protrude 1.5 to 2.5 mm above thread lip (A).

Fig 2: Identifying Protrude Dimension

Courtesy of BMW OF NORTH AMERICA, INC.

From the vehicle underbody:

Raise vehicle.

Manual emergency release of parking lock:

Illustration shows GA8HP transmission.

Remove UNDERBODY PROTECTION
Screw in bolt (1) with hexagon socket (SW5) until parking lock is released by lever (2).
It is imperative that bolt is always replaced.
Clean thread with screw tap size M6X1, 0.

Fig 3: Tightening Bolt With Hexagon Socket (Sw5)
Courtesy of BMW OF NORTH AMERICA, INC.

Screw new micro-encapsulated screw (1) into thread.

IMPORTANT:

Screwing in and adjusting of screw to 1.5 to 2.5 mm above thread lip (A) must occur within 3 minutes.

The screw may no longer be turned after 3 minutes (hardening of adhesive), otherwise it must be replaced.

Fig 4: Identifying Thread Lip Dimension

Courtesy of BMW OF NORTH AMERICA, INC.

From passenger compartment:

Refer to MANUAL EMERGENCY UNLOCKING OF PARKING LOCK .

From underneath vehicle with Bowden cable:

Illustration shows GA6HP transmission.
Remove rear UNDERBODY PROTECTION .
Press lever (1) towards rear.
Clamp lever firmly if permanently unlocking is desired.

Locking:

Release lever (1) or release clamping

Fig 5: Releasing Lever
Courtesy of BMW OF NORTH AMERICA, INC.