24 50 010 Replacing emergency actuator

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2014 BMW Alpina B7L, 2014 BMW Alpina B7, and 2013 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove CENTER CONSOLE .
Remove rear UNDERBODY PROTECTION
Remove left retaining plate from underbody protection
Support transmission with lifter.
Remove TRANSMISSION CROSSMEMBER .
Remove transmission support bracket

Unfasten nut.

Remove cable (1).

Installation note:

Adjust GEARSHIFT LEVER .

Fig 1: Identifying Cable Nut

G06889528

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Tightening torque 24 51 2AZ .

Release cable from pipe clamp (2).

Fig 2: Identifying Cable Of Pipe Clamp With Nut

G06889529

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE:

Reinstall transmission support bracket and transmission crossmember
Lower vehicle

Release nuts (1) and remove emergency actuator (2) in upward direction.

Fig 3: Identifying Actuator With Nuts

G06889530

Courtesy of BMW OF NORTH AMERICA, INC.