12 14 550 Replacing control unit (DME) (N63): Replacement

• Carry out programming/encoding
• If no data can be read out from the previous control unit, carry out injection quantity compensation (description at end of instructions).

Switch off ignition.

Release screw (1).

Lay filler neck (2) for windscreen washer fluid to one side.

Fig 1: Identifying Screw And Filler Neck

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 12 90 2AZ .

Remove electronics box cover (2).

Fig 2: Identifying Electronics Box Cover And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock all connectors (1) from control unit and disconnect.

Unclip grommet hold-down device (2) and remove.

Detach rubber grommets (3) from electronics box. Place wiring harnesses to the side.

Installation note: 

Make sure grommets are correctly seated (watertightness).

Fig 3: Identifying Control Unit Connectors, Grommet Hold-Down Device And Electronics Box Rubber Grommets

Courtesy of BMW OF NORTH AMERICA, INC.

Release outer locks on electronics box at front and rear.

Remove cover (1) from control unit.

Fig 4: Identifying Control Unit Cover And Electronics Box Outer Locks

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 12 90 1AZ .

Unclip coolant lines at clamp (2) from electronics box.

Release the electronics box (3) from the spring strut but do not remove.

Fig 5: Identifying Electronics Box, Clamp And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Press in lock (2) and detach coolant line (1) from control unit.

Catch and dispose of escaping coolant.

Lift out control unit.

Fig 6: Detaching Coolant Line From Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.