51 61 Reinforcement, body
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - REINFORCEMENT, BODY
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Suspension cross-brace, rear | F01/F02/F03/F04/F07/F10/F11/F12/F13/F18 | M10x47 | Replace bolts | |
| Jointing torque | 30 Nm | ||||
| Angle of rotation | 45 ° | ||||
| F25 | M10x25 | Replace bolts | |||
| Jointing torque | 56 Nm | ||||
| Angle of rotation | 90 ° | ||||
| 2AZ | Suspension cross-brace, front | F01/F02/F03/F04/F07/F10/F11/F12/F13/F18 | M10x47 | 56 Nm | |
| F01/F02/F03/F04/F07/F10/F11/F12/F13/F18 | M10x25 | Replace bolts | |||
| Jointing torque | 30 Nm | ||||
| Angle of rotation | 90 ° | ||||
| 3AZ | Connection, rear, to carrier support | F01/F02/F03/F04/F07/F10/F11/F12/F13/F18 | 28 Nm | ||
| 4AZ | Connection, front, to connection, rear | F01/F02/F03/F04/F07/F10/F11/F12/F13/F18 | 19 Nm | ||
| 5AZ | Engine compartment lid catch | F01/F02/F03/F04/F07/F10/F11/F12/F13/F18 | M8x20 | 11.8 Nm | |
| 6AZ | V-support to connection, front | F01/F02/F03/F04/F07/F10/F11/F12/F13/F18 | 19 Nm | ||
| 7AZ | Air duct, lower, to vertical strut | F01/F02/F03/F04/F07/F10/F11/F12/F13/F18 | 19 Nm | ||
| 8AZ | Air duct, lower, to support | F01/F02/F03/F04/F07/F10/F11/F12/F13/F18 | M8 | 8 Nm | |
| 9AZ | Air duct, upper, to lock support | F01/F02/F03/F04/F07/F10/F11/F12/F13/F18 | M8 | 8 Nm | |
| 10AZ | Torsion strut to side member | F07/F11/F12/F13 | M12x1.5x70 | Replace screws | |
| Jointing torque | 100 Nm | ||||
| Angle of rotation | 90 ° | ||||
| 11AZ | Torsion strut to compression strut, front (rear axle) | F07/F11/F12/F13 | M8 | 19 Nm | |
| 12AZ | Torsion strut to cross reinforcement (support, rear end) | F07/F11/F12/F13 | M12x1.5x53 | Replace screws | |
| Jointing torque | 100 Nm | ||||
| Angle of rotation | 90 ° | ||||
| 13AZ | Cross reinforcement (support, rear end) to rear end | F07/F11/F12/F13 | M10x22 | 38 Nm | |
| 14AZ | Cross reinforcement (support, rear end) to cross member | F07/F11/F12/F13 | M10 | 38 Nm | |