34 11 Front Brake F01/F02/F07
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
FRONT BRAKE SPECIFICATION
|
IMPORTANT:
New brake pads may only be fitted if the brake disc thickness is greater than the minimum brake disc thickness (MIN TH).
Minimum brake disc thickness during general inspection (GI): Nominal size thickness minus 2.4 mm (Not applicable to perforated brake discs and M vehicles) M vehicles and perforated brake discs: Nominal size thickness minus 1.6 mm Depending on:
different brake discs can be fitted The brake discs must always be assigned by way of the relevant vehicle identification number and the Electronic Parts Catalogue! |
||
| Different thicknesses on brake linings | Max. mm | 0.01 |
| Max. machining limit per friction ring side (M vehicles and perforated brake discs must not be machined). Brake disc minimum thickness (MIN TH) must not be undershot. |
mm | 0.8 |
| Nominal size (diameter x thickness) | mm | 324x30 |
| Nominal size (diameter x thickness) | mm | 374x36 |
| Nominal size (diameter x thickness) | mm | 348x36 |
| Brake disk minimum thickness (MIN TH) stamped on brake disk body | mm | 34.4 |
| Wear warning from residual lining thickness | mm | 3.7 |