Diagnosis instructions
WARNING: This page does not describe the selected car, but rather 45 other vehicles, including the 2016 BMW M5, 2016 BMW 550i xDrive, 2016 BMW 550i, 2016 BMW 535i xDrive, and 2016 BMW 535i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Preconditions for reset.
The RDC must be reset in the following cases:
- The tire pressure is changed.
- A wheel exchange is carried out. The exchanged wheels must be equipped with the correct wheel electronics systems.
- Axle-wise wheel exchange on the vehicle.
- Diagnosis instruction
NOTE:
Check of the wheel electronics system
A check as to whether the correct wheel electronics system has been fitted can only by run after the tire has been dismantled. Unfortunately, a query via the BMW diagnosis system is not possible for technical reasons.
NOTE:
Reset of the RDC control unit
During the reset, the control unit functions (measurement data of wheels 1 - 5) contain substitute values until the wheel allocation is complete (e.g. 6.4 bar; 127 °Celsius). To enable successful conclusion of the wheel allocation, the wheels must turn.