51 43 070 Removing and installing/replacing side trim panel, footwell, on A-pillar, left

Necessary preliminary tasks:

Release screw (1).

Remove hood/bonnet actuating lever (2) in direction of arrow from panel (3).

Fig 1: Removing Hood/Bonnet Actuating Lever From Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Detach mucket (2) in area of trim (5). See SEAL ON FRONT DOOR and NOTES ON SEALING INSTALLATION .

Release screw (1).

Unclip panel (5) in direction of arrow from retaining points (4).

If necessary, unlock plug connection of switch (3) and disconnect.

Remove trim (5).

Fig 2: Removing Panel From Retaining Points

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, lever out clips (1) remaining in bores.

If necessary, replace faulty clips (1).

Preinstall clip (1) in trim (2).

Replacement:

Press catches and remove switch (3) in direction of arrow.

Fig 3: Removing Switch

Courtesy of BMW OF NORTH AMERICA, INC.