23 12 510 Replacing radial shaft seal for drive shaft (GS6-53BZ/DZ)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

IMPORTANT: After completion of work, check TRANSMISSION FLUID LEVEL .

Use only approved transmission oil.

Failure to comply with this instruction will result in serious damage to the transmission.

Necessary preliminary tasks:

Release screws.

Tightening torque: 23 11 2AZ .

Remove guide tube (1).

Installation:

Clean guide tube.

Do not grease guide tube.

Fig 1: Locating Guide Tube Screws

Release screw on special tool 23 3 200 .

Push special tool onto drive shaft and screw into sealing ring.

Fig 2: Pushing Special Tool Onto Drive Shaft

Insert screw into special tool 23 3 200 again and continue turning until sealing ring is pulled out of transmission housing.

Fig 3: Turning Screw Into Special Tool (23 3 200)

Installation:

Coat sealing lips of radial seal with gear oil.

Push radial seal (1) onto drive shaft up to housing.

Drive in radial seal (1) as far as it will go with special tool 23 3 220 and plastic hammer.

Fig 4: Pushing Radial Seal Onto Drive Shaft