23 12 089 Replacing radial shaft seal for selector shaft (GS6-53BZ/DZ)
WARNING: This page is about a different variant/trim than selected.
Special tools required:
IMPORTANT:
After completion of work, check TRANSMISSION FLUID LEVEL .
Use only approved transmission oil. Failure to comply with this instruction will result in serious damage to the transmission.
Necessary preliminary tasks:
- Shift transmission into 2nd gear
- Unflange propeller shaft from transmission.
Tasks are described in Removing PROPELLER SHAFT .
Lever retaining ring (1) out of groove with a small screwdriver.
Slide locking ring (1) towards rear.
Drive out cylinder pin (2).
Screw in special tool 23 0 210 until it is firmly connected with radial seal (1).
Pull out radial seal with special tool 23 0 210 .
Coat sealing lips of radial seal and selector shaft with transmission oil.
Drive in radial seal with special tool 23 0 220 .