17 00 515 Checking function of radiator and heating system

WARNING: This page is about a different variant/trim than selected.

Special tools required:

WARNING: Danger of scalding!
Only carry out work on cooling system after engine has cooled down.

Necessary preliminary tasks:

Check production date.

Fig 1: Locating Production Date

Courtesy of BMW OF NORTH AMERICA, INC.

Clamp off low-temperature feed lines with special tool 13 3 010 .

Function test:

Observe diagnosis instructions.

Fig 2: Clamping Special Tool (13 3 010) And Low Temperature Feed Lines

Courtesy of BMW OF NORTH AMERICA, INC.

Check function of radiator.

Clamp off low-temperature feed line (1) at coolant pump outlet or radiator inlet with special tool 13 3 010 (see arrows).

Fig 3: Locating Low Temperature Feed Line

Courtesy of BMW OF NORTH AMERICA, INC.

Automatic transmission only

Check function of heat exchanger.

Clamp off low-temperature feed line (1) at coolant pump outlet with special tool 13 3 010 (see arrow).

Clamp off low-temperature feed line (2) at oil-coolant heat exchanger with special tool 13 3 010 (see arrow).

Fig 4: Locating Low Temperature Feed Lines

Courtesy of BMW OF NORTH AMERICA, INC.

Check heating and cooling circuits in accordance with diagnosis instruction.