28-1 10 Housing with add-on parts
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - HOUSING WITH ADD-ON PARTS
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Oil-coolant heat exchanger to S65 transmission | GS7D36SG | M6 | 10 Nm | |
| 2AZ Holder, oil-coolant heat exchanger to S65 transmission | GS7D36SG | M6 | 8 Nm | |
| 3AZ Oil thermostat to transmission | GS7D36SG | M8x60 | 19 Nm | |
| 4AZ Hydraulic line to oil thermostat | GS7D36SG | M8 | 19 Nm | |
| 5AZ Transmission input speed sensor to transmission | GS7D36SG | M6 | 9 Nm | |
| 6AZ Instrument cluster sensor, oil pump, to transmission | GS7D36SG | M6 | 6 Nm | |
| 7AZ Oil pump spray plate to transmission | GS7D36SG | 10 Nm | ||
| 8AZ Oil pump to transmission | GS7D36SG | M6 | Position: 1, 2, 5, 6, 7, 8 to final torque. Position: 1 loosen and to final torque. |
10 Nm |
| 9AZ Oil pump pressure pipe to transmission | GS7D36SG | M8 | Position: 3 and 4 to final torque | 25 Nm |
| 10AZ Clutch support to transmission | GS7D36SG | 11 Nm | ||
| 11AZ Aluminum screws/bolts, earth cable to transmission | GS7D36SG | Jointing torque | 5 Nm | |
| 12AZ Suction jet pump to transmission | GS7D36SG | M8 | 6 Nm | |
| 13AZ Suction filter to transmission | GS7D36SG | M6 | Screw (1) Screw (2) | 5 Nm 8 Nm |
| 14AZ Output flange | GS7D36SG | Collar nut installed with screw locking Pretension Release Tighten down |
175 Nm 125 Nm |