13 71 Intake silencer
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - INTAKE SILENCER
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Pure air bellows to throttle valve | N52K | Hose clamp | 3 Nm | |
| 2AZ Gaiter to intake muffler | N52K | Hose clamp | 3 Nm | |
| 3AZ Intake silencer to body | N52K | M6 | 8 Nm | |
| 4AZ Intake port to front panel | N52K/N54/N54T | Sheet metal screw | 2 Nm | |
| 5AZ Air duct to intake silencer | N54/N54T | Hose clamp | 3 Nm | |
| 6AZ Air duct to crankcase | N54/N54T | M6 | 9 Nm | |
| 7AZ Charge air guide to holder | N54/N54T | M6 | 9 Nm | |
| 8AZ Air duct of compressor to engine block | N54/N54T | M6 | 9 Nm | |
| 9AZ Pressure sensor to charge air cooler duct | N54/N54T | M6 | 2 Nm | |
| 10AZ Engine sound system to charge air duct | N54/N54T | Hose clamp | 3 Nm | |
| 11AZ Engine sound line to sound system | N54/N54T | Hose clamp | 3 Nm | |
| 12AZ Bracket for air duct to cylinder head | N54/N54T | M6 | 9 Nm | |
| 13AZ Air intake hose to throttle body | N52K | Hose clamp | 3 Nm |