23 00 Transmission in general
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - TRANSMISSION IN GENERAL
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Transmission to engine TRANSMISSION DESIGNATIONS . | ||||
| Hex screws | B/C/D/E/F/G/H/I/7-speed SMG | M6 | 8 Nm | |
| B/C/D/E/F/G/H/I/7-speed SMG | M8 | 25 Nm | ||
| B/C/D/E/F/G/H/I/7-speed SMG | M10 | 49 Nm | ||
| B/C/D/E/F/G/H/I/7-speed SMG | M12 | 74 Nm | ||
| Torx bolt | B/C/D/E/F/G/H/I/7-speed SMG | M6 | 9 Nm | |
| B/C/D/E/F/7-speed SMG | M8 | 19 Nm | ||
| B/C/D/E/H/I/7-speed SMG | M10 | 43 Nm | ||
| G-transmission | M10 | 38 Nm | ||
| 7-speed SMG | M10x55 8.8 | 43 Nm | ||
| 7-speed SMG | M10x42 8.8 | 42 Nm | ||
| Steel screws with Torx head | I/G/H/K transmission | M8 | 19 Nm | |
| Steel screws with Torx head | I/G/H/K transmission | M12 | 66 Nm | |
| 2Az Transmission to engine N52/N52K/N53/N54/N55 Aluminum screws/bolts are not magnetic. | I/G/H-transmission | Replace screws Jointing torque and angle of rotation must be observed without fail | ||
| I/G/H-transmission | M10x30 | Jointing torque Angle of rotation |
20 Nm 90-110° |
|
| I/G/H-transmission | M10x85 | Jointing torque Angle of rotation |
20 Nm 180-200° |
|
| I/G/H/K transmission | M12 | Jointing torque Angle of rotation |
25 Nm 130 ° +20° |
|
| 3AZ Cover plate, transmission | I/H-transmission | M6 | 8 Nm |