13 62 531 Replace coolant temperature sensor (N54, N54T)

WARNING: This page is about a different variant/trim than selected.

WARNING: Risk of scalding!
Only perform this repair work on an engine that has cooled down.

Recycling

Catch and dispose of escaping coolant.

Observe country-specific waste disposal regulations.

Necessary preliminary tasks:

NOTE: Coolant temperature sensor is mounted on cylinder head at front.

Release connector (1) and remove.

Unfasten coolant temperature sensor (2).

Installation note:

Tightening torque 13 62 1AZ .

If necessary, top up coolant.

Check COOLING SYSTEM for leaks.

Fig 1: Identifying Coolant Temperature Sensor And Connector

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault messages.
Delete fault memory.