11 65 Turbocharger and Control
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - TURBOCHARGER AND CONTROL
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Flange nut (with internal serrations) Exhaust turbocharger to cylinder head | N54/N54T | M7 | Replace flange nut. | 20 Nm |
| 2AZ ASA screw Heat shield/retaining plate to crankcase upper part |
N54/N54T | M6 x 16 | 8 Nm | |
| 3AZ ASA screw Holder EPPC to cylinder head |
N54/N54T | M6 x 20 | 9 Nm | |
| 4AZ Bracket, air duct, compressor 2, to cylinder head | N54/N54T | M6 x 15 | 9 Nm | |
| 5AZ Vacuum reservoir to bracket for vacuum reservoir | N54/N54T | M8 | 20 Nm | |
| 6AZ Bracket, vacuum reservoir, to body | N54/N54T | M6 x 14 | 5 Nm | |
| 7AZ Bracket to engine longitudinal member | N54/N54T | M6 | 5 Nm | |
| 8AZ EPPC to bracket, EPPC, with heat shield | N54/N54T | M6 | 5 Nm | |
| 9AZ Hexagon nut Vacuum unit (wastegate valve) to bracket | N54/N54T | M6 | 8 Nm | |
| 10AZ Lock nut to vacuum unit (wastegate valve) linkage | N54/N54T | M6 | 7 Nm | |
| 11AZ Hexagon screw Bracket, vacuum unit (wastegate valve), to turbocharger |
N54/N54T | M8 | 20 Nm | |
| 12AZ Band clamp Charge-air duct to turbocharger. |
N54/N54T | M6 | Replace band clamp. | 3.5 Nm |