11 12 Cylinder head with cylinder head cover
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - CYLINDER HEAD WITH CYLINDER HEAD COVER
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Cylinder head bolt | N54/N54T | M11 x 135 | Replace screws. | |
| Jointing torque | 30 Nm | |||
| 1. Angle of rotation | 90 ° | |||
| 2. Angle of rotation | 90 ° | |||
| 3. Angle of rotation | 45 ° | |||
| 2AZ Cylinder head bolt | N54/N54T | M9 x 95 M9 x 125 | Replace screws. | |
| Jointing torque | 30 Nm | |||
| 1. Angle of rotation | 90 ° | |||
| 2. Angle of rotation | omitted | |||
| 3. Angle of rotation | 45 ° | |||
| 3AZ Cylinder head bolt | N54/N54T | M9 x 30 M9 x 70 | 22 Nm | |
| 4AZ Cylinder head cover to cylinder head. | N54/N54T | M6 | 8.5 Nm | |
| 5AZ Metal holder to cylinder head. | N54/N54T | M6 x 16 | 8 Nm | |
| 6AZ Lifting eye to cylinder head. | N54/N54T | M8 x 20 | 19 Nm | |
| 7AZ Ignition coil cover to cylinder head cover. | N54/N54T | M6 x 20 | 4 Nm | |
| 8AZ Hexagon screw (2 x) Metal bracket for ignition coil cover to cylinder head cover. | N54/N54T | M6 x 12 | 4 Nm |