11 12 Cylinder head with lid N54
WARNING: This page is about a different variant/trim than selected.
CYLINDER HEAD WITH LID SPECIFICATION
| Cylinder head height: Original dimension | mm | 112.00 ±0.05 |
| Machining limit | mm | 111.70 ±0.05 |
| Valve guides are not available as replacement parts. | ||
| Inner diameter of installed valve guide | ||
| Original intake valve | mm | 5.00...5.02 |
| Original exhaust valve | mm | 6.00... 6.02 |
| Tilt clearance, maximum (wear between valve and valve guide) |
mm | cannot be measured |
| Bearing of camshaft | ||
| Guide bearing (width) | mm | 22.00... 22.05 |